Other

A BETTER REMOTE FOR ANY CABLE OPERATED DROPPER An Aluminum remote with an oversized bearing and a super smooth action. The unique lever position allows you to keep a stronger grip on the bars while actuating your post. Don't think twice about dropping your post, even when charging into technical sections. The OneUp lever mimics your R/H shifter’s inboard upshift paddle position instead of the usual downshift paddle position of most remotes. This position requires considerably less thumb movement to reach the lever. NO BLEEDING The cable setup is quick and easy. The cable clamps at the lever making shortening the housing length for clean routing a breeze. Unlike a hydraulically actuated dropper, there is no temperature sensitivity and If your remote gets damaged you can still lower or extend your post by removing it from your frame and pushing on the actuator by hand. - Kit includes cable and housing - Compatible with all cable actuated dropper posts.

Don’t get stuck between dropper sizes. The unique OneUp travel adjust shims allow you to custom tune your post by lowering the travel and extended length of your post by as much as 50mm in any increment you like. Want an oh so fashionable 128.99mm drop? You got it! Drop tuning can be done on-bike, tool free and without removing the saddle or touching a shock pump. Lowering the post travel also increases bushing overlap, which is great for heavier riders. - Compatible with V1 Droppers only - 170mm Dropper Post - adjustable down to 120mm - 150mm Dropper Post - adjustable down to 100mm

This kit includes all the parts required to rebuild your V1 Dropper Post. - Replacement Seal - Upper and lower bushings - Anti-rotation pins - Compatible with V1 Dropper Post ONLY. We have found that ~95% of posts with slow top out were caused by low air pressure. Please make sure to check this first and do so with the post fully extended. Proper air pressure is 280-300psi at full extension, and the valve is located under the top clamp. If you are still having slow top out then there is a possibility that the upper white bushing needs replacement. This will be evident by the original bushing being difficult to reinstall after being removed.

This kit includes all the parts required to rebuild your V2 Dropper Post. - Replacement Seal - Upper and lower bushings - Anti-rotation pins - Compatible with V2 Dropper Post ONLY.

V2 dropper remote clamp for 22.2mm handlebar.

Replacement dropper post remote clamp. Can be used to convert existing clamp on the OneUp Dropper Remote. - Compatible with Shimano I-Spec EV (M9100, M8100, M7100) brake mounts. - Does not contain remote body.

Set of six oversized pins. All dropper posts require key way clearance. With so many different frames, clamps and ride heights it's not possible to ship play-free without running the risk of binding. The kit is meant to remove additional play that might develop over time or, for the more mechanically inclined, to tune the play out for a specific bike. Start with the 3 pins marked with 2 lines. If play still exists move to the 3 pins marked with 4 lines.

Don’t get stuck between dropper sizes. The unique OneUp travel adjust shims allow you to custom tune your OneUp Components Dropper post by lowering the travel and extended length of your post by either 10mm or 20mm. A 180mm travel post can be reduced in travel to either 170mm or 160mm with this shim kit. Drop tuning can be done on-bike, tool free and without removing the saddle or touching a shock pump. Lowering the post travel also increases bushing overlap and alignment pin length, which is great for heavier riders. - 210mm Dropper Post - adjustable down to 190mm - 180mm Dropper Post - adjustable down to 160mm - 150mm Dropper Post - adjustable down to 130mm - 120mm Dropper Post - adjustable down to 100mm